This solar power device creates pulsing vibration waves through the ground. These waves can effectively repel snakes up to a 30 metre diameter area.
The pulsing vibration waves simulate danger to a snake. The snake senses this through its body. Once the snake enters the defensive area, the pulsing vibration irritates the snake which encourages it to depart that location.
It is strongly recommended that a minimum of two (2) devices are used and installed 25 metres apart.
The Solar Snake Repeller is powered by a solar cell and a rechargeable accumulator stores power for operation at night. When the accumulator is fully charged, it can supply enough power for night operation, thereby ensuring a continuous around-the-clock repeller.
A full day of sunshine will fully recharge the device and enable it to operate for approximately 3 cloudy days.
Power supply: Ni-Cd cell recharged by solar energy.
Working Range: about 625 square meters
DO'S AND DON'TS
DO charge the solar panel for two days before installation and connection of the cables.
DO install in solid soil. The density of the soil will greatly impact the effectiveness of the penetration of the pulsing vibration waves.
DO install the green head at least 50ml above ground level.
DO ensure the solar panel is exposed to direct sunlight.
DO NOT install in frozen, irrigated or water logged soil.
DO NOT use a hammer when installing as this may cause damage to the device.
DO NOT use excessive force when installing as this may cause damage to the device.